CAN interface ⭐   Pro

The CAN interface allows you to trigger tracks saved on the satellite via CAN. Enable CAN mode by selecting Protocol Mode and the CAN Bus protocol in the External trigger configuration.

Set CAN Mode
../../settingspanel/externaltrigger/

The CAN parameters are the following:

TX pin
GPIO Pin 1
RX pin
GPIO Pin 2
Baud rate
500 kbit/s
Identifier
11-bits: 0x320

Upload tracks

Start by uploading assigning tracks to slots by opening the external trigger interface and enabling the CAN interface.

Set CAN Mode
../../settingspanel/externaltrigger/
Next, locate the list of slots.

For each slot, you can select an 8-bit identifier and assign a track to be associated with that identifier. In order to assign the track, simply press the "Assign Track" button and subsequently click the track you would like to assign.

Start a track

Send a message with at least one byte of data. The first byte will be interpreted as the identifier of the track to play. If no track has been assigned to the identifier, no playback occurs.